Aspire Tigon Kit

Aspire Tigon Kit


Aspire Tigon AIO Kit

  • 1 x Tigon Kit(2.0ml)
  • 1 x Glass tube
  • 1 x Extra drip tip
  • 1 x 0.4Ω DL (preinstalled)
  • 1 x 1.2Ω MTL
  • 10 x O-rings
  • 1 x Warranty Card
  • 1 x Screw adjustment tool
  • 1 x User Manual
  • 1 x USB Cable

You might need this

Aspire Tigon AIO Kit

The Aspire Tigon AIO Kit is a stick inspired unit which is easy to use and child safe. It is very stylish and sleek, and comes in four great finishes, Stainless Steel, Blue, Rainbow and Black. The Aspire Tigon AIO Kit can be used as a mouth to lung or a restricted direct to lung vape. It works on a bypass mode output with a battery capacity of 1800mAh which is more than enough to keep you going through the day.

The device is very slim line with a height of 123mm and width of 23mm, and wont take too much space in the pocket/purse. The Aspire Tigon Tank that sits on top is a 2ml capacity chamber which comes with 2 drip tips. One is very short and stubby for maximised cloud and the other is very long and narrow for the mouth to lung hits. The device has only one button located on the front of the tube which is used for turning on and off as well as a firing button. The micro USB port is located on the back, while the tank has an airflow control ring to switch between the mouth to lung and direct to lung depending on the coil.

The Tigon Tank uses a 0.4ohm coil for direct to lung and also has a 1.2ohm coil for mouth to lung, but Aspire have recently released a 0.7ohm Mesh Coil for better wicking and a more flavourful vape. The coils are very easy to replace by unscrewing the base of the Tigon Tank and pulling the coil out. The chamber can remain full of e-liquid and wont leak due to a self sealing sleeve which is spring loaded in the wicking holes, allowing it to remain full and will open up again once a new coil is pushed in.

The Aspire Tigon Kit has built in safety features such an an Automatic Cut Off, Short Circuit Protection, Low Voltage Protection, Overcharge Protection and an Over Heat Protection. In regard to charging the unit, the firing button has an LED indicator to show the battery level, 3.5v or less is red, 3.5v to 3.8v is blue and when the charge is over 3.8v, the light is pink. When the device is fully charged it will flash 20 times and then remain off. We rate this device 10 out of 10.

  • E-Liquid Sealing Mechanism
  • Child Proof Safety Features
  • Top Fill Tank
  • MTL and DL
  • 1.2Ω (10w-12w) / 0.4Ω (23w-28w)
  • Bypass Output
  • Output Voltage of 3.3V – 4.2V
  • Continuous Firing time of 10 Seconds
  • Battery Capacity – 1800mAh (built in)

Additional information


, , ,


There are no reviews yet.

Add a Review

Be the first to review “Aspire Tigon Kit”